IMPORTANT SAFETY INSTRUCTIONS• Install the Over-the-Air Module with care. Be sure not to drop any loose parts in the opening.• Do not insert anything
Page 9REMOVING THE OTA MODULEDo not remove the OTA Module unless necessary as you will no longer be able to tune to your over-the-air channels if the
Page 10TROUBLESHOOTINGThe receiver does not detect that the OTA Module is installed1. The receiver will display that the OTA Module is detected on the
Page 113. Verify the module is installed correctly. Refer to the instructions on page 3.4. Verify that the antenna is installed correctly and peaked f
Page 12ABOUT OVER-THE-AIR TV BROADCASTSOver-the-air TV signals are broadcast by local TV stations from a transmitter tower, and are received using an
Page 13Installation Considerations• Follow local, state, and National Electric Code requirements for grounding the over-the-air antenna.• RG-6 coaxial
Page 14Limited WarrantyThis Limited Warranty is a legal document. Keep it in a safe place. Remember to keep your Sales Receipt for warranty service. W
Page 15CONDITIONAL ACCESS NUMBERS, HAS BEEN ALTERED OR REMOVED. THIS WARRANTY SHALL ALSO BE VOID IF THE DEVICE HAS BEEN OPENED BY AN UNAUTHORIZED PERS
Page 16its sole discretion determines has voided the warranty, or makes the equipment unrepairable, your billing account or credit card will be charge
Page 17Copyright © 2008. EchoStar Technologies L.L.C., Englewood, Colorado 80112. All rights reserved.The information in these Installation Instructio
TABLE OF CONTENTSPage 1INTRODUCTION...2INSTALLATION AND SETUP ...2Installation Consi
Page 2INTRODUCTIONThe MT2 Over-the-Air (OTA) Module allows you to add two digital over-the-air tuners to your satellite receiver. This provides the ab
Page 3• These instructions assume you have an over-the-air antenna suitable for your area already installed in your system. Refer to www.antennaweb.or
Page 4The module port on the back of the satellite receiver must be covered if an OTA Module is not installed. Damage to an uncovered module port is n
Page 54. Connect the cable from your over-the-air antenna to the OVER-THE-AIR ANTENNA IN port on the module (see Figure 3). Only one cable is needed b
Page 6Setting up the Receiver to Display OTA Channels1. Using the remote control, press MENU, select System Setup, then Local Channels.Note: Your Loca
Page 76. Select a channel and then select Edit Name to change the way the channel name displays in the Program Guide and other channel lists. You can
Page 8a similar name. Refer to your TV’s User Guide for help locating this connection.4. Using the satellite receiver’s remote control, press MENU, se
Komentáře k této Příručce